Dacor Refrigerator E6 Error: Ice maker fault
This dacor refrigerator error code e6 guide explains what this fault means for your Dacor appliance and how to respond safely. What Error Code E6 Means Error code E6 on Dacor DRF36 and DRF42 French Door refrigerators signals an ice maker fault. The ice maker control module has detected a problem in the harvest or […]
20%
DIY Fixable
From $250
Typical Repair Cost
60-120 min
Pro Repair Time
Quick Assessment
Answer to continue safely
Is it safe to keep using?
Yes. E6 affects only the ice maker system. The refrigerator and freezer cooling functions remain unaffected, so food safety is not compromised.
Can I reset the code?
Yes. The ice maker reset button or panel toggle can clear E6 if the root cause was a transient jam or sensor glitch. If ice production does not resume within 24 hours, further diagnosis is needed.
When to stop immediately?
Stop if you notice: Stop if the ice maker still does not produce ice after 24 hours post-reset., Stop if you hear the water valve buzzing but no water enters the mold — valve replacement needed..
Symptoms You May Notice
Ice production has stopped
The ice maker no longer produces ice cubes, and the ice bin remains empty or at its last level.
E6 on the display
The control panel shows E6, sometimes with the ice maker indicator light flashing.
Hollow or misshapen cubes before stop
Prior to E6 appearing, ice cubes may have been undersized, hollow, or clumped together, indicating a water fill issue.
Water dispenser still works
The water dispenser continues to function normally, suggesting the issue is isolated to the ice maker subsystem rather than the water supply line.
Possible Causes
Jammed ice maker ejector
A malformed cube or foreign object has jammed the ejector arm, preventing the harvest cycle from completing.
DIY PossibleFailed water inlet valve (ice maker branch)
The solenoid valve that supplies water to the ice maker mold has failed closed, so no water enters the mold.
DIY PossibleIce maker thermostat or module failure
The ice maker's internal thermostat or electronic module has failed and must be replaced as a unit.
Requires ProfessionalSafe Checks You Can Do
-
1
Reset the ice maker
Locate the ice maker reset button (usually a small recessed button on the side of the ice maker module). Press and hold for 3 seconds until you hear a chime. Allow 24 hours for a new batch to form.
On some Dacor models, toggling the ice maker Off and On via the display panel performs the same reset function.
-
2
Check for ice jam in the bin or ejector
Remove the ice bin and inspect the ejector tines for stuck cubes. Clear any obstruction by hand. Inspect the water fill tube for ice blockage (a common issue in low-humidity environments).
A turkey baster with warm water can clear a frozen fill tube without disassembly.
-
3
Verify water supply pressure
Confirm the water supply line shut-off valve is fully open and that household water pressure is 20–120 PSI. Low pressure can prevent the inlet valve from opening.
A pressure gauge at the supply line connection provides a definitive reading.
Tools required
When to Call a Professional
Contact a qualified technician if:
- Ice maker module tests indicate a failed harvest thermostat — full module replacement needed.
- Water inlet valve solenoid has failed — requires water line disconnection and valve swap.
- Leak detected from the fill cup or mold — may require ice maker removal and seal replacement.
Need Professional Help?
Find qualified technicians in your area for proper diagnostics and repair.
Refrigerator Repair Service Schedule Appointment