Dacor Dishwasher E15 Error: Base pan flood detected
Dacor dishwasher error code e15 — essential information for Dacor appliance owners. This dacor dishwasher e15 error code guide explains what this fault means for your Dacor appliance and how to respond safely. What E15 Means E15 is the Aqua-Stop flood-protection code. A polystyrene float in the base pan rises when water accumulates there and […]
~20%
DIY Fixable
From $200
Typical Repair Cost
60-120 min
Pro Repair Time
Quick Assessment
Answer to continue safely
Is it safe to keep using?
No. The flood protection system has detected water in the base pan. Running the dishwasher before finding and fixing the leak source risks water damage.
Can I reset the code?
Yes. Tilting the unit to drain the base pan and drying the float switch may clear E15. The underlying leak must still be identified and repaired.
When to stop immediately?
Stop if you notice: Water reappears in the base pan within one wash cycle of drying it out, You can see or feel a wet spot on the kitchen floor beneath the unit.
Symptoms You May Notice
Dishwasher stops mid-cycle and beeps
The unit halts during a wash or rinse phase and produces an alert tone. E15 appears on the display or status indicator.
Water detected in the base pan
The float switch in the base pan has been triggered, indicating water has escaped the tub and collected in the protective pan beneath the unit.
Dishwasher will not start new cycle
After E15 triggers, the unit refuses to begin a new cycle until the base pan water is removed and the float switch resets.
Slight water stain on floor under unit
A small amount of water may be visible on the floor at the front of the dishwasher where it has seeped from the overflow pan.
Possible Causes
Leaking tub seal or spray arm fitting
A worn seal around the wash motor shaft or a cracked spray arm connector allows water to drip into the base pan during operation.
Requires ProfessionalLoose or cracked water supply connection
The water inlet connection at the valve or supply hose has a small leak that drips into the base pan during fill cycles.
DIY PossibleDoor gasket failure at bottom corner
The rubber door gasket is worn or displaced at a bottom corner, allowing small amounts of water to escape during spray arm rotation.
DIY PossibleSafe Checks You Can Do
-
1
Tilt and inspect base pan
Disconnect power and water supply. Carefully tilt the dishwasher forward to see if water drains from the base pan area. Note the approximate volume.
A few tablespoons suggests a slow drip; a full pan suggests a sudden hose or seal failure.
-
2
Inspect door gasket
Close the door and run your finger along the inside of the door gasket, especially at the bottom corners. Feel for gaps, tears, or areas where the gasket does not make firm contact with the tub opening.
Dried food debris stuck to the gasket can prevent a proper seal — clean the gasket with warm soapy water.
When to Call a Professional
Contact a qualified technician if:
- Active internal leak from a hose, pump seal, or spray-arm fitting is confirmed
- Float switch itself has failed and remains triggered even when the base pan is dry
- Door gasket replacement does not stop water from entering the base
Need Professional Help?
Find qualified technicians in your area for proper diagnostics and repair.
Dishwasher Repair Service Schedule Appointment