Dacor Dishwasher E25 Error: Drain pump blocked
Dacor dishwasher error code e25 — essential information for Dacor appliance owners. This dacor dishwasher e25 error code guide explains what this fault means for your Dacor appliance and how to respond safely. What E25 Means E25 is a drain-pump jam code. When the control board sends power to the drain pump motor but detects […]
~55%
DIY Fixable
From $150
Typical Repair Cost
30-60 min
Pro Repair Time
Quick Assessment
Answer to continue safely
Is it safe to keep using?
Maybe. Running the wash motor without water can damage the pump seals. Do not start cycles until the water fill problem is corrected.
Can I reset the code?
Yes. Opening the supply valve fully or cleaning the inlet valve screen often resolves E25 immediately.
When to stop immediately?
Stop if you notice: Pump hums loudly on every drain attempt — impeller may be broken, Water remains in the tub after removing visible blockage.
Symptoms You May Notice
Dishwasher does not fill with water
The cycle starts but no water enters the tub. The wash motor may attempt to run dry, producing a loud grinding sound.
Low water level in tub
Some water enters but not enough to reach the spray arms effectively. Dishes on upper rack remain completely dry and uncleaned.
E25 appears within first few minutes
The control board detects insufficient water level after the fill timeout period and halts the cycle with E25.
Clicking sound from inlet valve area
A rapid clicking may be audible from the water inlet valve as it tries to open but cannot, often due to low water pressure or valve failure.
Possible Causes
Clogged or failed water inlet valve
Mineral scale has blocked the inlet valve screen or the valve solenoid has failed, preventing water from entering the dishwasher.
DIY PossibleInsufficient water supply pressure
The home water pressure is too low (below 20 PSI) for the inlet valve to open fully, often caused by a partially closed supply valve under the sink.
DIY PossibleFailed water level sensor
The pressure switch or float sensor that tells the board the tub is empty has failed, so the board does not command the fill valve to open.
Requires ProfessionalSafe Checks You Can Do
-
1
Check water supply valve
Open the cabinet under the sink and verify the dishwasher hot water supply valve is fully open. Turn it counterclockwise to ensure maximum flow.
After plumbing work, supply valves are sometimes left partially closed.
-
2
Clean inlet valve screen
With the water supply off and the dishwasher disconnected from power, remove the supply line from the inlet valve and check the small mesh screen inside the valve for mineral buildup or debris.
Soak the screen in white vinegar for 30 minutes to dissolve mineral deposits.
Tools required
When to Call a Professional
Contact a qualified technician if:
- Impeller is cracked or missing blades and the full pump must be replaced
- Pump body housing is cracked from a hard foreign object impact
Need Professional Help?
Find qualified technicians in your area for proper diagnostics and repair.
Dishwasher Repair Service Schedule Appointment